| Code | Description | Possible Remedy | |------|-------------|------------------| | 1-1 | Contactor weld detected | Inspect main contactor; replace if stuck closed | | 2-3 | Accelerator sensor out of range | Calibrate pedal (see Section 8.4) | | 4-5 | Motor temperature sensor open | Check wiring at drive motor; replace sensor | | 5-2 | Encoder signal loss (drive motor) | Inspect encoder harness; realign encoder disk | | 6-7 | Hydraulic pump overcurrent | Test pump motor insulation; check for hydraulic lock | 3.4 No Lift – But Pump Motor Runs
3-WHEEL ELECTRIC FORKLIFT TRUCK
Model Series: 7HBW23 Capacity: 2,300 kg (5,070 lbs) Voltage System: 48V AC
| Step | Action | Expected Result | |------|--------|------------------| | 1 | Check hydraulic fluid level (warm, forks lowered) | Between min/max marks on tank | | 2 | Inspect lift relief valve pressure | Should be 175–180 bar (2,538–2,610 psi) | | 3 | Test lift spool valve manual override | If lift works manually, solenoid coil failed | | 4 | Measure coil resistance at connector | 10–15 ohms typical; replace if open/short |
SERVICE MANUAL
| Code | Description | Possible Remedy | |------|-------------|------------------| | 1-1 | Contactor weld detected | Inspect main contactor; replace if stuck closed | | 2-3 | Accelerator sensor out of range | Calibrate pedal (see Section 8.4) | | 4-5 | Motor temperature sensor open | Check wiring at drive motor; replace sensor | | 5-2 | Encoder signal loss (drive motor) | Inspect encoder harness; realign encoder disk | | 6-7 | Hydraulic pump overcurrent | Test pump motor insulation; check for hydraulic lock | 3.4 No Lift – But Pump Motor Runs
3-WHEEL ELECTRIC FORKLIFT TRUCK
Model Series: 7HBW23 Capacity: 2,300 kg (5,070 lbs) Voltage System: 48V AC toyota 7hbw23 service manual
| Step | Action | Expected Result | |------|--------|------------------| | 1 | Check hydraulic fluid level (warm, forks lowered) | Between min/max marks on tank | | 2 | Inspect lift relief valve pressure | Should be 175–180 bar (2,538–2,610 psi) | | 3 | Test lift spool valve manual override | If lift works manually, solenoid coil failed | | 4 | Measure coil resistance at connector | 10–15 ohms typical; replace if open/short | | Code | Description | Possible Remedy |
SERVICE MANUAL